Quote request only.This product is not available for sale online. Contact us for more information.
The Scorpion Towable Attenuator (TA) is a mobile crash cushion designed with a tongue and axle/wheel that connects directly to the support vehicle's pintle hook from a lunette ring on the attenuator. The TA can be used on support vehicles with a minimum actual/curb weight of 10,000 lbs with no upper weight limit (infinite weight). The TA has overall dimensions of 17.8ft (5.4m) × 8ft (2.4m) × 4.3ft (1.3m) with ground clearance of 12" ± 1" (305mm ± 25mm). The TA consists of three main components: the attenuators tongue, front Strut, and rear Cartridge. The attenuators tongue is positioned nearest to the support vehicle, the Strut is bolted to the tongue and Cartridge. The Cartridge is the rear most component, furthest away from the support vehicle. The coupler acts as a standard single point connection under normal towing conditions. The attenuators tongue is designed with an integral Telescoping Anti-Rotation System (TARS) that is activated when the TA is impacted. The forward sliding action occurs during an impact, upon completion of the full telescoping action the outboard anti-rotation supports come into contact with support vehicle frame plate which in turn prevents angular rotation about the rear of the host vehicle. The Strut consists of four outboard convex aluminum tubes forming an aluminum structural weldment. The aluminum structural weldments bolt directly to the TARS tongue and the rear Cartridge. The structural assembly encompasses the aluminum crush Module D. The Cartridge consists of four outboard convex aluminum tubes forming an aluminum structural weldment. The aluminum structural weldments bolt directly the Struts steel angles and rear diaphragm. The TA uses a Cartridge Diaphragm with an axle/wheel attachment for towing the TA. The structural assembly encompasses the two-aluminum crush Module C's. Attached to the rear most end of the Cartridge is the single crush Module A. The Scorpion® TA is the only trailer attenuator to be tested and accepted by the NCHRP-350 TL-3 and MASH in the U.S and M.T.Q. with a 10,000 lbs host vehicle.
Signoplus is a large sign manufacturer of signage (street names, traffic signs, signage for bicycle paths, industries, road transport, transport of dangerous goods, tourism (pictograms), signs in inuktitut and cree, emergency stops for school buses, custom panels, posts and mounting hardware (fasteners). Signoplus uses the following materials: aluminum, CoroplastMC, PlexiglasMD, retroreflective sheeting, vinyl sheetings (stickers), fiberglass, CrézonMD, AlumaliteMD, LusterboardMD, Omega-BondMD and magnetic vinyl.